Advertisement
A. Flush Mount Chassis (AES-2005F)
The AES-2005F comes with a zinc-plated steel
rough-in box and a black powder-painted steel
mounting ring. The rough-in box is meant to be
framed into the wall. Make sure the outer edge
of the box is within 1/4 inch of the finished surface
of the wall, but not protruding past the surface
level.
Knockouts are provided in the box to
accommodate conduit entrance from the sides or
bottom.
The
temperatures up to 130 degrees Fahrenheit. If
the unit is installed where it is exposed to direct
sunlight, the front panel can exceed this maxi-
mum temperature. Above this specified maxi-
mum rating, the buttons will become hot for the
tenants to press and the LCD display will go dark.
Step 1. After the wall is finished, the mounting ring can be screwed to the rough-in box.
Step 2. Once the mounting ring is secure, the front panel of the AES-2005S can be fastened to the ring using the 3 screws and
nuts provided by aligning the hinge with the three holes on the right side of the frame.
Make sure the key lock is in the open position.
Step 3. Insert the screws and tighten the nuts firmly.
Be careful not to damage the foam gasket around the back edge of the panel.
If the enclosure
is to be mounted outdoors,
use an appropriate sealant
around the outer edge of the
mounting ring.
To help steer visual-
ly impaired visitors to the
location of the
button, the optional Braille
"Audio" label may be adhered
above the push button.
B. Surface Mount Chassis (AES-2005S)
The AES-2005S comes with a black powder
painted steel surface mount chassis.
knockout is provided on the bottom of the
chassis as an alternate wire entrance. The
four outer holes on the back of the chassis
are for mounting the box to the wall.
The
ate at temperatures up to 130 degrees
Fahrenheit. If the unit is installed where it is
exposed to direct sunlight, the front panel
can exceed this maximum temperature.
Above this specified maximum rating, the
buttons will become hot for the tenants to
press and the LCD display will go dark.
is rated to operate at
Mounting Ring
(included)
* Optional Braille
"Audio" label
(included)
AUDIO
AES-2000
(3) Screws (included) for mounting
the AES-2000 to the ring
A
is rated to oper-
Set
Screw
Front View of Steel Rough-In Box
12.25"
9.75"
9.74"
1.26"
4.87"
0.875" Diameter Knockout
Hinge
6.13"
4.5"
4.83"
9.66"
0.875" Diameter
Knockout
Right Side View (same as
Left Side minus Knockout)
1.25"
0.875" Diameter
Knockout
(8) 0.187"
Diameter Holes
1.25"
Bottom View (same as Top
2.5"
View minus Knockout)
0.45"
Steel Rough-In Box
(included)
0.875" Diameter
(8) Screws (included) for mounting
Sealant
12.26"
9.0"
1.5"
(4) 0.26" Diameter
3.0"
Typical
(4) 0.16" Diameter
Typical
0.45"
1.25"
3.625"
7.25"
The rough-in box
should be framed
into the wall.
Knockout
the ring to the rough-in box.
(2) 0.20" x 0.43"
Slots Typical
3.0"
4.0"
1.5"
1.65"
3.0"
3.3"
6.0"
4.0"
3
Advertisement
