Care And Maintenance; Specifications - Pioneer GM-2000A Owner's Manual

Care and Maintenance
Specifications
Enough care must be taken against battery overdischarge caused
by long operation of the set at a high sound level when the
engine is not running or is idling.
The protection circuitry will operate instantaneously should any
malfunctions occur, shutting off all sound. Under such circum-
stances, disconnect the power of the car stereo system, check the
wiring for any possible causes and correct them before operating
the stereo system again.
When replacing the fuse, replace it with a fuse having the correct
capacity.
Dust the heat sinks occasionally so that they will not become
clogged.
In Case of Trouble
When the unit does not operate properly, contact your dealer of
the nearest authorized PIONEER Service Station.
Power SOUICE .........020000008- 14.4 V DC (10.8-15.6 V allowable) |
Grounding System ........ cece eee tere eee eeenes Negative type
Max. current CONSUMPTION ....... 06. cece eee eet eees 15A
Dimensions ...........2.-00e scene eee 265 (W) x-48 (H) x 232 (D) mm
Weight ...............2..05- 3.0 kg (Leads for wiring not included)
Maximum power output ............2.0 eee eee 100 W x 2/200 W x 1
Continuous power output
60 W x 2/120 W x 1 (at 4.Q, 1 kHz, 1% THD)
Becher MAS SO te att erce hitad Nat Mags ie theta ech ava, ttl 50 W x 2/100 W x 1
(at 4 Q, 20-20,000 Hz, 0.015%/0.03% THD)
Load impedance ...........0 cece eee e eee rene 4 Q (2-8 Q allowable)
Frequency response ..........-...00-+ 10—50,000 Hz (+0 dB, —1 dB)
Signal-to-noise ratio ............ 0. eee eee 102 dB (IEC-A network)
DIStOMTION SE 5 oix.5, 55:6 «Sie dete oe: a ae woe aie get ee 0.005% (at 50 W, 1 kHz)
Low-pass filter cut-off frequency. ..........2.20000. 80 Hz
Low-pass filter cut-off slope..............04- 12dB/octave
Input level 0.0.0... cece ee eee eee eee eee ees DIN: 70-500 mV/22 kQ
RCA :0.2-2 V/7 kQ
Note:
Specifications and the design are subject to possible modification
without notice due to improvements.
TH
7 4
QO:
c
as)
ae