Table of Contents
Advertisement
CONTENTS
FEATURES. siiiivassivenstt recs saneoudaGass alavince aa aeageenteebelensaatiness
estes: 2
INSTALEATION
cove tax. verecveseianannniabennetanscameusav
eg save ccatsivnviatedanney 2
PANEL FACILITIES -wccc-ciescsyctsnucicadedescaersbadaag
taentvavalh Gheageeusaesncas 3
CONNECTIONS:
sccccicscaeniiasaheutessnactsaasasncnuaaeanncantein
tearventeaves 6
OPERATIONS, sescscssnsdnsiesniat
opiiesataxoyicas entiagadeananunesiitesnnacemneare 8
TROUBLESHOOTING tsi: cswastsenonasssanebncrannycanudsbdauisiiersavueteneiey
10
SPECIFICATIONS <ccviscyrcasvedequngetececninaunpenttinaasmansotenmavanetieenescs 11
FEATURES
e Drive capacity 80 W + 80 W/4 Q matching to high power and low
impedance type speaker system.
[Model A-302 ........cccccecscecceccsececceseeseessesaes
50 W + 50 W/4 Q)
¢ Super Linear Circuit is employed to realize high-quality sound with
minimum distortion.
@The
use of a DIRECT circuit ensures
high fidelity playback of
consistent frequency characteristics, with maximum clarity.
eClean
ground
technology
prevents
noise
on
power
line from
flowing
to
the
signal
ground
line,
permitting
clean
sound
reproduction.
e Uses Channel Separation Enhancer Circuit to improve the stereo
sound field and sound quality.
® REC selector switch makes tape editing very simple.
@Honeycomb
Chassis,
Honeycomb
Heat Sink.
(Thorough
anti-
vibration construction).
e Uses a complementary capacitor pair.
INSTALLATION
LOCATION
Install the unit in a well-ventilated location where it will
not be exposed to high temperature or humidity.
Do not install the unit in a location which is exposed
to direct
sunlight, or near hot appliances or radiators. Excessive heat can
adversely affect the cabinet and internal components. Installation of
the unit ina damp or dusty environment may result in malfunction or
accident. (Also, avoid installation near cookers, etc., where the unit
may be exposed to smoke from oil, steam or heat.)
CONDENSATION
When this unit is brought into a warm
room from previously cold
surroundings
or
when
the
room
temperature
rises
sharply,
condensation may form inside, and the unit may not be able to attain
its full performance. If this occurs, allow the unit to stand for about
an hour or raise the room temperature gradually.
2
<ARB1433>
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by tugging
the cord and never touch the power cord when your hands are wet as
this could cause a short circuit or electric shock. Do not place the unit,
a piece of furniture, etc., on the power cord, or pinch the cord. Never
make a knot in the cord or tie it with other cords. The power cords
should be routed such that they are not likely to be stepped on. A
damaged power cord can cause fire or give you an electrical shock.
Check the power cord once in a while. When you find it damaged, ask
your nearest PIONEER authorized service center or your dealer for a
replacement.
MAINTENANCE OF EXTERNAL SURFACES
e Use a polishing cloth or dry cloth to wipe off dust and dirt.
e When the surfaces are very dirty, wipe with a soft cloth dipped
in some neutral cleanser diluted five or six times with water,
and wrung out well, and then wipe again with adry cloth. Donot
use furniture wax or cleaners.
e Never
use
thinners,
benzine,
insecticide
sprays
and
other
chemicals on or near this unit, since these will corrode the
surfaces.
Advertisement
Table of Contents
