7.18. Rear Frame Assy Removal
In this section, the procedure of removing a rear frame effi-
ciently for exchange of each part in the sections from 7.19
to 7.23 is indicated.
* The Rear Frame is in the state to which the Fan, Fan
Holder, Fastener and Hinge are attached.
1. Remove the Rear Plate.
(Refer to "7.5. Rear Plate Removal")
2. Remove the screws and then remove the Corner Metal1.
3. Lift the Rear Frame Assy quietly and remove it.
Attention when attaching the Rear Frame Assy
• When attaching the Rear Frame Assy, the gasket attached
to the Panel Holder Bottom Assy is in contact with the Rear
Frame Assy certainly.
Attention when attaching the fan joint connector
• When you connect the fan joint connector, check the number
of fan joint connector and number of fan indicated in the fol-
lowing figure, and connect it so as not to make a mistake.
If connection of a connector is mistaken, abnormal operation
will be caused.
35
TH-47LFX6U/TH-47LFX6W