Panel Holder Bottom Assy Replacement - Panasonic TH-47LFX6U Service Manual

Caution when attaching to the Front Frame Assy
• Have the (A) part and the (B) part of the previous figure, and
place it quietly. When placing it, please match the position of
the V1-Board and the position of the window (printing-less
part) of the Front Frame Assy.
7.20. Panel Holder
Replacement
1. Remove the Rear Plate.
(Refer to "7.5. Rear Plate Removal")
2. Remove the Rear Frame Assy.
(Refer to steps 2 to 3 in "7.18. Rear Frame Assy
Removal")
3. Prepare a setting position.
(Refer to "Preparations" and step 3 in "7.19. Panel Holder
Top Assy Replacement")
Bottom Assy
Cautions when replacing the Panel Holder Top Assy
37
4. Disconnect the connector and remove the screws, and
then remove the Panel Holder Bottom Assy quietly.
• Remove a tape of the lead wire attached to the Panel Holder
Bottom Assy and then remove a lead wire.
• When replacing the Panel Holder Bottom Assy, you order
the "Tape Kit" for repair simultaneously, and please restick
an aluminum tape and a tape simultaneously.
• Wire Holder MG is not contained in the Panel Holder Bottom
Assy for repair. Therefore, please remove and reuse the
Wire Holder MG at the time of panel replacement.
• Wire Holder MG is the part for not damaging a lead wire.
In a state of attaching the Wire Holder MG, please perform
the wire processing so as not to damage the lead wire.
• Stick the gasket in the center of the paint-less area of Panel
Holder Bottom Assy after attaching the Rear Frame Assy.
TH-47LFX6U/TH-47LFX6W