Panel Holder Top Assy Replacement - Panasonic TH-47LFX6U Service Manual

TH-47LFX6U/TH-47LFX6W
7.19. Panel Holder
Replacement
Preparations
• Please prepare two hard square lumber and spread soft
cloth etc. on it.
1. Remove the Rear Plate.
(Refer to "7.5. Rear Plate Removal")
2. Remove the Rear Frame Assy.
(Refer to steps 2 to 3 in "7.18. Rear Frame Assy
Removal")
3. Because it is in a state where only the sponge of a panel
touches the frame, in order to make parts replacement
easy, and in order to do not damage the frame, please
have the (A) part and the (B) part of the following figure,
detach it, move it onto the prepared square lumber which
spread soft cloth, and place it quietly.
Top Assy
4. Remove the screws and then remove the Panel Holder
Cautions when replacing the Panel Holder Top Assy
• Remove a tape of the lead wire attached to the Panel Holder
Top Assy and then remove a lead wire.
• When replacing the Panel Holder Top Assy, you order the
"Tape Kit" for repair simultaneously, and please restick an
aluminum tape and a tape simultaneously.
• Wire Holder MG is not contained in the Panel Holder Top
Assy for repair. Therefore, please remove and reuse the
Wire Holder MG at the time of panel replacement.
• Wire Holder MG is the part for not damaging a lead wire.
In a state of attaching the Wire Holder MG, please perform
the wire processing so as not to damage the lead wire.
36
Top Assy quietly.