Cleaning The Brushroll; Cleaning The Dirty Water Tank - Shark HYDROVAC WD100 Series Instruction Booklet

MAINTAINING YOUR 3-IN-1 CLEANER

CLEANING THE BRUSHROLL

1. To access the brushroll, press the button on the top
of the nozzle and lift off the brushroll cover.
2
1
3. Reinsert the brushroll by lining up the grooves on the
end of the brushroll with the helix on the inner right side
of the nozzle, then press down on the left side of the
brushroll. When properly installed, the brushroll tab will
be flush with the left side of the nozzle.
NOTE: Do not place brushroll in washing machine or dishwasher. Replace the brushroll after 6 months.
s h a r kc l e a n . c o . u k
1
2. Remove the brushroll by pulling up on the pull tab on
the left side of the nozzle.
Wash thoroughly with warm water. Allow the
brushroll to air-dry completely in a well-ventilated
area for at least 24 hours.
3
1
2
1
4. To reinstall the brushroll cover, insert the hooks on
the bottom of the cover into the unit first. Press
down on the cover until it clicks into place.
MAINTAINING YOUR 3-IN-1 CLEANER

CLEANING THE DIRTY WATER TANK

2
1. To remove the dirty water tank, press the release
button and pull out the tank.
4
3. To dispose of solid debris, lift out the Solids
Separator. Grasp the recessed areas on the sides of
the separator and lift it out. Empty the solid debris
into the trash. If any liquid waste remains in the tank,
pour it down a drain. To clean, rinse the separator
and the tank with water.
NOTE: Replace the filter every 6 Months.
NOTE: Do not place dirty water tank in washing machine or dishwasher.
1
2. To dispose of liquid waste only, pour it out though
the Express Clean Spout on the back of the dirty
water tank.
3
Pull
from here
4. Clean the filter in the top of the solids separator
every month. Pull out the filter and hand-wash
with warm water and soap. Allow the filter to
air-dry completely in a well-ventilated area before
reinstalling it.
s h a r kc l e a n . c o . u k
2
4