Self-Cleaning Mode - Shark HYDROVAC WD100 Series Instruction Booklet

USING YOUR 3-IN-1 CLEANER
POWER
Press and release the Power button on the handle
to turn on power. To turn off power, press the
button again.
CLEANING MODES
HARD FLOOR MODE
Use Hard Floor mode for powerful cleaning on bare
floors. To activate Hard Floor mode, turn on the unit
and tilt the handle back.
NOTE: To prevent leakage, DO NOT place the main body on the floor. The nozzle should always be kept flat on the floor.
NOTE: If you encounter a difficult stain, use Freshen Mode for improved stain cleaning.
NOTE: If you encounter a stubborn odor on your floor or area rug, continue to clean in Freshen Mode until the odor is gone.
NOTE: If your floors are cloudy, streaky, or spotty after cleaning, it may be due to accumulated soap or grease residue. The
floor may require several cleanings with the Hydrovac.
s h a r kc l e a n . c o . u k
CONTROLS
FRESHEN MODE MODE
To clean area rugs, press the Freshen Mode icon on
top of the handle. The Freshen Mode light on the
main body will illuminate. To turn off Freshen Mode
mode, press the button again.
MAINTAINING YOUR 3-IN-1 CLEANER

SELF-CLEANING MODE

RECOMMENDED AFTER EVERY USE
1. Place the unit on the Storage Dock. The Self-
Clean mode icon located on the top of the main
body will pulse.
2. Empty the Dirty Water Tank and make sure the
clean solution tank is at least half full.
3. Press the Power Button to start the self-clean
cycle. The icon will illuminate for the full 2-minute
duration of the cycle.
4. DO NOT remove the unit from the tray during the
self-cleaning cycle. The icon will turn off when the
cycle is complete.
5. Empty the dirty water tank.
See Troubleshooting for more information on
Self-Clean information.
NOTE: Make sure the clean solution tank is at least half full and that the dirty water tank is empty before running the self-
cleaning cycle.
s h a r kc l e a n . c o . u k