Cleaning The Brushroll; Checking For Blockages; Cord Maintenance - Shark Navigator Lift-Away ZU503AMZ Owner's Manual

MAINTENANCE
Self-Cleaning Brushroll
Shark's self-cleaning brushroll automatically removes hair wrap. If some hair remains wrapped
around the brushroll, continue cleaning to give it time to make its way to the dust cup. If you run
over a hard or sharp object or notice a noise change while vacuuming, check for blockages or
objects caught behind the brushroll.

CLEANING THE BRUSHROLL

Using a coin, turn locks
counterclockwise, then open
the cover to access Brushroll.
NOTE: Cover hinges open but
is not completely removable.
DEBRIS
WRAPPED
AROUND
BRUSHROLL
Clean off any debris on the bristles.

CORD MAINTENANCE

To minimize the risk of power cord damage, DO NOT run the vacuum over the power cord. If this
occurs, immediately shut off power to the vacuum and remove the cord from the brushroll or nozzle.
s h a r kc l e a n . c o m
DEBRIS BEHIND
BRUSHROLL
If you vacuum up a hard or sharp object, or
notice a noise change while vacuuming,
remove any blockages or objects caught
behind the brushroll.
Clear away any dust, dirt, or blockages in
Debris Intake.
To close the cover, push down until it clicks into
place, then close the locks with a coin.
1. DO NOT pull or carry vacuum cleaner by
the cord or use cord as a handle.
2. DO NOT unplug by pulling on the cord.
Grasp the plug, not the cord.
3. DO NOT close the door on the cord.
4. DO NOT pull the cord around sharp
corners.
5. DO NOT leave the cord near heated
surfaces.

CHECKING FOR BLOCKAGES

WAND BLOCKAGES
Detach wand from floor nozzle and handle, and
check both ends for blockages.
HANDLE/HOSE BLOCKAGES
Detach handle from wand and hose from the
vacuum pod, and check openings for blockages.
NOZZLE BLOCKAGES
Detach floor nozzle from wand and vacuum pod,
tilt nozzle neck back, and check opening for
blockages.
DUST CUP BLOCKAGES
Detach dust cup from vacuum pod. Empty dust
cup, remove debris from lint screen, and check for
blockages.
s h a r kc l e a n . c o m