Installing Battery (For Remote Control); Cleaning Instructions - ViewSonic LiteBird PJ853 User Manual

Installing Battery (for remote control)

• Use a 3V micro lithium battery as shown in the illustration.
• The battery is not rechargeable.
Pull the plastic tab from the battery access door when using the new projector for the first time.
1
Pinch the battery holder at the bottom of the remote control and gently pull out the holder with
2
the battery.
Gently pop the battery out of the holder and replace it with a new battery.
3
The + side of the battery should be facing up as shown in the illustration.
4
5 Push the battery and holder back into the battery slot. The holder should click into place.

Cleaning Instructions

Projector Lens
• Clean the lens with a damp, non-abrasive cloth. Apply a lens cleaning solution or a glass cleaning
solution to the cloth. Do not spray a cleaning solution directly onto the lens.
Projector Case
• Make sure the projector is cool before cleaning.
• Clean the exterior case with a moist cloth using a mild detergent.
Do not use alcohol, benzene, or other chemical cleaners which could damage the case.
WARNING:
Pull out
Battery Holder
Figure 9: Installing the Battery
"+" side
ViewSonic PJ853
E
N
G
L
I
S
H
16