Loading The Battery; Initial Battery Loading; Replacing Remote Control Battery; Figure: 4 Battery - ViewSonic PJ500 User Manual

Loading the Battery

Initial Battery Loading

In the original packing, the battery is installed in the battery holder of the remote control with
protective film (to preserve battery life while unit is not is use).
Carefully pull out the protective film, then load the battery following to the procedure below.

Replacing Remote Control Battery

See the reverse side of the remote control.
Figure 4: Battery
Pinch the groove and pull out battery holder. See graphic above.
1
Remove the used battery.
2
Install the new battery with "+" side facing up.
3
Push in the battery holder until it "clicks."
4
Warnings
• Incorrect handling of the battery could result in fire or personal injury.
• The battery may explode if not handled properly.
• Use the 3V micro-lithium battery, type number CR2025 only.
• When loading the battery, make sure the plus and minus terminals are correctly oriented as indicated in the remote
control.
• Dispose of the battery in accordance with local laws and regulations.
• Keep the battery away from children and pets.
• When not to be used for an extended period, remove the battery from the remote control.
NOTE: When remote control operation becomes difficult, replace the batteries.
5 ViewSonic PJ500