Remote Control Battery Installation; Remote Control Operating Range; Remote Control Code; Adjustable Foot - ViewSonic PJL6223 User Manual

Part Names and Functions
Open the battery
1
compartment lid.
To ensure safe operation, please observe the following precautions :
Always replace batteries in sets.
Do not use a new battery with a used battery.
Avoid contact with water or liquid.
Do not drop the remote control.
If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
Dispose of used batteries according to the instructions or your local disposal rule or guidelines.
Point the remote control toward the projector (Infrared
assigned to this projector. Switching the remote
control codes prevents interference from other remote
controls when several projectors or video equipment
the remote control code for the projector first before
changing that for the remote control. See "Remote control"
Press and hold the MENU and IMAGE buttons for more
than five seconds to switch between the Code 1 and Code
2. The initial code is set to Code 1.
the adjustable foot.
the projector.
Release the foot lock latch to lock the adjustable foot and
rotate the adjustable foot to adjust the position and
tilt.
To retract the adjustable foot, lift the front of the projector
and push and undo the foot lock latch.
Keystone distortion of the projected image can be corrected

Remote Control Battery Installation

Install new batteries
2
into the compartment.

Remote Control Operating Range

Remote Control Code

Adjustable Foot

12
Replace the
3
compartment lid.
Two AAA size batteries
For correct polarity
battery terminals are
in contact with pins in
compartment.
Adjustable Foot
(5 m)
Remote control
MENU button
IMAGE button