Table of Contents
Advertisement
Warnings and safety notes
20
Personnel operating the machine should be trained regularly. Un-
trained personnel must not be allowed access to the machine or its
controls.
Take care when handling chemical agents. These may contain irrit-
ant, corrosive or toxic ingredients.
Please observe the chemical agent manufacturer's safety instructions
and safety data sheets.
Wear protective gloves and goggles.
The machine is designed for operation with water and recommen-
ded additive chemical agents only. Organic solvents and flammable
liquid agents must not be used in it.
This could cause an explosion, damage rubber or plastic components
in the machine and cause liquids to leak out of it.
Any seals on the load items should be protected against prolonged
contact with wash water. Therefore, always close unused connec-
tions with protective caps or blind covers.
The water in the cabinet must not be used as drinking water.
Be careful when sorting items with pointed ends. Position them in
the machine so that you will not hurt yourself or create a danger for
others.
When using this machine in the higher temperature ranges, be es-
pecially careful not to scald or burn yourself or come into contact with
irritant substances when opening the door. Where disinfecting agents
are used there is a danger of inhaling toxic fumes.
Where there is a risk of toxic or chemical substances occurring in
or leaking into the suds solution (e.g. aldehyde in the disinfecting
agent), it is essential to regularly check door seals and make sure that
the steam condenser is functioning correctly. Opening the machine
door during a programme interruption carries particular risks in such
circumstances.
Should personnel accidentally come into contact with toxic va-
pours or chemical agents, follow the emergency instructions given in
the manufacturer's safety data sheets.
After using the hot air drying unit, open the door to allow the
everything in the cabinet from the load itself to the mobile units, mod-
ules and inserts to cool down.
Mobile units, modules, inserts and the load must be allowed to
cool down before they are unloaded. Any water remaining in contain-
ers could still be very hot. Empty them into the wash cabinet before
taking them out.
Advertisement
Table of Contents
