KitchenAid K5-A Service Instructions Manual page 21

B. Check the rubber feet (40). If they are worn or softened
from grease, replace them. Twist the old feet out. Clean the
holes with solvent and dry them with clean cloth. Oil or
grease the part of the foot that will go into the hole and t wist
the new feet in. Be sure all feet are in the same amount .
C. If the bowl screw cap ( 40) has worn out, replace it. To
remove the old cap , take out the three
oll:
10-24 x 1 /2" flat
head screws (39) and lift out the old cap. Place new cap in
place and screw it down tight with the three screws (39).
D. Place the gear case and motor housing ( 1) on the pedestal.
Line up the holes for the hinge pin ( 44) and drive it in so that
an equal amount of the pin extends on each side of the
pedestal.
E. Turn the mixer upside down on padding for it to rest on.
With a screwdriver, reach up inside pedestal and tighten the
cup point set screw (51).
20
SECTION 6
ADJUSTMENT OF CONTROL UNIT
A. After installing new parts in the control unit, the control
plate (2, Fig. 2) must be adjusted so that all speeds will be
the same as they were when the mixer was new.
B. Make sure that all of the wire leads are properly
connected and that they are locked together firmly with the
wire connectors ( 1 0). Plug the cord into a receptacle having
the proper voltage.