KitchenAid K5-A Service Instructions Manual page 20

T. The agitator shaft (32) is complete as an assembly. Oil the
shaft and push it up into the bearing as far as it will go. Place
the washer (43) or (44) on shaft. Place the pin (33) through
the shaft. Set the pinion gear ( 45) on shaft and straddle the
pin (33). Place retaining washer ( 4 7) on pinion and screw the
assembly to the shaft with the
#
10-32 x 5
I
16" flat head screw
(46).
U. Be sure the planetary has a good supply of grease and that
the wicking (27) and the clip (26) are in good condition. Use
Shell Darina No. 2 lubricant.
V. Place the washers (17) on the vertical shaft (13) . Place the
planetary on the shaft and push it up to the washers. Line up
the holes in planetary and shaft and drive in the groove pin
(19). Place the drip cup (34) on the gear case. Use care so
"0" ring will not be damaged.
W. Check the adjusting screw ( 48). This screw is slotted and
has a nylon insert. As it is screwed in, the threads are cut in
the nylon and hold the screw tight. Replace this screw if it is
loose in the threads.
SECTION 5
REPAIRS TO K45 PEDESTAL
A.
Check the hinge pin ( 4 2, Fig. 1 ). If it is galled from
failure to loosen the set screw ( 49), replace it. Loosen the set
screw so that it will clear the hinge pin. Place the new hinge
pin in the pedestal ( 41) but do not drive it in.
19