Alfa Network QUICK 2 User Manual page 44

to obtain a flame as yellow and as bright as possible, however stop before soot depos-
its on the cupola.
Flame F1 has to switch off only in the case where:
• The oven operator switches off the burner using the
• The oven exceeds the limit T° (set in factory at
• Intervention of the safety thermostat, vacuum "unsuitable environment".
The adjustment criteria of flame F1 are:
• Increase in the T° (to be avoided); operate on the gas adjustment screw, reducing its
flow;
• Amount of light produced;
• Soot (to be avoided).
2
ND
The 2 flame (F2) can be manually adjusted in 6 power positions, by pressing the but-
nd
tons "+" and "-" on the control panel.
This adjustment is designed to lower the 2
order to prevent the upper part from burning.
STEP
1
2
42
FLAME (F2) POWER ADJUSTMENT
PICTURE
flame power during product cooking, in
nd
During the oven heating phase,
press the "A" button until position
"6" is selected on the "B" indicator,
in order to quickly reach the operat-
ing temperature.
Once the operating temperature
has been reached, the high flame
turns off, the oven temperature
drops (7°C) and then the high flame
back on. Adjust, if required, the
power of the high flame by using
the "+" and "-" buttons depending
on work needs.
The second flame switch autom-
atism remains active once it has
reached the set temperature, but
once it restarts with the setting
made previously using the "+" and
"-" buttons on the scale 1-6.
"ON/OFF" red button;
450°C).
ACTION