Graco 253479 Instructions-Parts List Manual

Drip shield kit

Download this manual

Instructions - Parts List

Drip Shield Kit

Model 253479

For heated drum unloaders with 6.5 in. dual post rams

. . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

ti7863a

Important Safety Instructions

Read all warnings and instructions in this manual.

Save these instructions.

GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441

Parts

. . . . . . . . . . . .

. . . . . . . . . . . . . . . .

311509 rev.A

Page 1: Table Of Contents
....ti7863a Important Safety Instructions Read all warnings and instructions in this manual. Save these instructions. GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441 Copyright 2002, Graco Inc. is registered to I.S. EN ISO 9001...
Page 2: Symbols
Symbols Warning Symbol Caution Symbol WARNING CAUTION This symbol alerts you to the possibility of serious This symbol alerts you to the possibility of damage to injury or death if you do not follow the instructions. or destruction of equipment if you do not follow the instructions.
Page 3: Installation
Installation 1. Raise drum platen to full UP position. 2. Install drip tray mounting brackets approximately 1 to 2 inches below bottom of platen. See Fig. 1. 3. Place drip tray inside U–channel bracket (1). CAUTION 4. Change drums. Do not over tighten “U” bolts on ram cylinders. Over 5.
Page 4 Notes 4 311509...
Page 5: Parts
Parts Models 253479 Drip Shield Mount Kit 3, 4 ti7862a Ref. Ref. Part No. Description Qty. Part No. Description Qty. 15E026 BRACKET, drip shield mount 15H609 BOLT, U, 6 in. pipe 100133 WASHER, lock 100131 NUT, full hex 115694 SHIELD, 29.9 X 27.3 X 1/8 in.
Page 6: Operation
Graco distributor to the original purchaser for use. With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.