Graco 234026 Installation Manual

Gun splitter valve

Installation

Gun Splitter Valve

Part No. 234026

7250 psi (50 Mpa, 500 bar) Maximum Working Pressure

The splitter valve allows you to use two spray guns with

one proportioner. It can be used with one gun or two

and provides for independent flushing of each gun

while the other gun remains in use.

Important Safety Instructions

Read and follow warnings and instructions in

your proportioner and other component manuals.

Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441

309964 rev. C

Table of Contents

Need help?

Do you have a question about the 234026 and is the answer not in the manual?

Page 1 Important Safety Instructions Read and follow warnings and instructions in your proportioner and other component manuals. Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441 Copyright 2003, Graco Inc. is registered to I.S. EN ISO 9001...
Page 2 Installation 2. Close the paint valve (D or E) for the gun to be flushed. F . 1. 1. Connect the mixed material supply line (A) from the proportioner to the manifold paint inlet port. F . 1. WARNING 2. Connect a hose (B) between each manifold gun To avoid splashing, use the lowest possible pressure paint outlet and spray gun fluid inlet.
Page 3 Fitting Sizes Proportioner; 3/8 npt(m) Paint Inlet Port; 3/8-18 npt(f) Gun Paint Outlet; 1/4-18 npt(f) Solvent Inlet Port; 1/4-18 npt(f) Solvent OPEN Solvent CLOSED Supply Supply Pump Pump SOLVENT 1 SOLVENT 2 INLET INLET PAINT INLET OPEN CLOSED OPEN CLOSED GUN 1 GUN 2 OUTLET...
Page 4 Parts Parts TI8961 Part Description‘ Part Description‘ 626062 NEEDLE, 2K2 sst hardened 15A959 MANIFOLD, splitter, gun 104319 PACKING, o-ring 15C756 HOUSING, splitter, gun 2 185467 SEAT, valve 102915 PIN, drive 171860 GASKET, seat 596936 SCREW, cap socket hd 1/4-20 x 1.5 15B587 HOUSING, stem, solvent 100721 PLUG, pipe 15B086 STEM, paint...
Page 5 Parts 309964C5...
Page 6 With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.