Kawai XR9000 Owner's Manual page 82

TROUBLE SHOOTING (WAIT, It's NoT BROKEN!)
Cause/Check
Select the tone block for a keyboard using the KEYBOARD CONDUCTOR tabs. Please note
that the tone for the LOWER keyboard you selected with the KEYBOARD CONDUCTOR
tabs will not play if you are using the AUTO PLAY ORCHESTRA feature with the one
finger chord button.
PLAY MODE
1. The keyboard makes no sound.
Motors, neon, or other equipment can be a source of electrical interference creating
noise in the sound output. Try changing locations and plug into an outlet that is not being
used by devices that draw a lot of current.
2. The product generates noise.
This may happen when there is a broadcasting station near the organ. Consult your
authorized KAWAI dealer.
3. You can hear the TV or radio sound.
This is not a defect. The DRAWBAR 1-3/5, 1-1/3, and 1 sounds are designed to repeat in
the high pitch range.
4. The Drawbar sound repeats in the high
pitch registers.
TREMOLO is not available when the CHORUS tab is off. Press both the TREMOLO and
5. TREMOLO not working.
CHORUS tabs to activate the TREMOLO effect or tremolo speed is set too slow.
Percussion sound may not be available in legato playing. Release the first note and then
play the next note.
6. Percussion not sounding.
This is not a defect. The XR7000 PEDAL keyboard has no touch feature. The XR9000
PEDAL keyboard responds to initial touch only. After touch effect for the SYNTHESIZER
section is not available.
7. Touch feature is not available in the
PEDAL keyboard
11. Knee Lever function is not available. Knee lever does not function if the "KNEE LEVER function" is deactivated with the KNEE
LEVER setting mode.
Pressing the INTRO/ENDING tab only does not start the Ending pattern. Ending starts
when you pressing the INTRO/ENDING switch during the rhythm performance, and then
press the footswitch or the TOUCH BAR to which the FILL/ENDING feature is assigned.
12. Ending does not start.
There are some chords and/or inversions that your organ cannot recognize. See the
"CHORD CHART" on the page 76 for the chords that the XR series organ can recognize.
13. The chord you play on the LOWER keyboard
is not displayed on the display.
(a) When the DRAWBAR piston lamp is not lit, the current drawbar tone is selected instead
of the Drawbar tone of the Registration memory.
(b) When the RHYTHM FIX switch lamp is lit, the AUTO PLAY ORCHESTRA settings will
not be called up.
14. The REGISTRATION feature does not recall
the setup you want to recall.
(a) Turn the disk write protect off (close the window of the disk).
(b) Format the floppy disk with your XR series organ.
(c) When there is little memory left in the disk, you may not be able to record a song. Use a
floppy disk which has enough memory space for recording.
(d) If the PUNCH IN-OUT feature is activated, the punch in recording will start instead of the
normal recording. In that case, deactivate the PUNCH IN-OUT setting with the
Sequencer Edit Mode.
15. Disk Sequencer recording is not available.
16. Pressing the PLAY or RECORD switch does
not playback or record immediately.
It takes some time to save or load registration and rhythm data when the SYSTEM track
button is activated. Turn the SYSTEM track button off to deactivate the saving/loading to
start playback or recording quickly.
71