Table of Contents
Advertisement
7-7 Sequencer Edit
Punch In/Out is a technique for re-recording specific portions of a
previously recorded track.
(1) Select a song to re-record. (See pages 24, 25, 26 for details.)
(2) Press the SEQ button in the EDIT section. The button lamp lights
and you'll see the Punch In-Out display.
(3) Turn the Dial to select the value "ON".
Punch
ON
In-Out
(4) Press the right CURSOR button. The display shows "Track" on
the lower left side.
In—-Out
Track
--
Solo
Punch
(5) Use the Dial to select the track you want to re-record.
(6) Press the right CURSOR button. The display shows "Start Bar"
on the lower left side.
In—-Out
00005
Punch
Start
Bar
(7) Use the Dial to select the measure number where you want to
begin recording.
48
(8) Press the right CURSOR button. The display shows "End Bar" at
the lower left side.
In-Out
00008
Punch
End
Bar
(9) Use the Dial to select the measure number where you want
recording to stop.
(10) Press the SEQ button to leave the Punch In/Out Setting mode.
(11) Press the PLAY button to start recording. New data replaces
the old in the region you specified.
Note: If you press any other button in the SEQUENCER section (ex.
STOP button), the Punch In/Out function will be automatically set to
"OFF".
(12) Press the STOP button when you finished the recording in the
region you specified. The Punch In/Out setting will be turned off
automatically.
Note: When you select the lower value for the End Bar than that for
the Start Bar, the End Bar value will be set to the same value as that
of the Start Bar. in that case, Punch In/Out will be applied to that bar
only.
NOTES:
Advertisement
Table of Contents
