Getting Ready To Play - Kawai XR9000 Owner's Manual

Getting Ready to Play
1. Insert the plug end of the AC power cord into the outlet.
2. Press the power switch to turn the unit on.
(When there is no disk in the disk drive, Display 7 will show the
following message: set XR disk)
Volume Adjustment
3. Set the TOTAL VOLUME switches at mid range of volume.
Note: All volume controls on your XR9000/7000 feature a conve-
nient set of tiny instantaneously acting electronic switches,
placed vertically on each volume control. The switch at the bot-
tom of the control will produce the softest volume. As you press
the switch higher up on the control the volume will increase.
When two adjacent switches are pressed at the same time, the
volume is set to the mid point between the levels by the two
switches.
TOTAL VOLUME
4. Depress the expression pedal halfway
This pedal controls the volume of the organ's overall volume.
During a performance, use of this pedal adds dynamic levels.
Note: About the unit's internal memory
The XR series organ is equipped with a back-up battery to main-
tain data in memory even when the power is turned off. This bat-
tery has a lifetime of ten years although this can depend some-
what on operating conditions. When the back-up battery begins
to run down, the WRITE piston in the REGISTRATION MEMORY
section blinks several times when you turn the power on.
You cannot back up the internal memory once the back-up bat-
tery has run out of power. For a replacement of back-up battery,
contact your authorized KAWAI Dealer.
Kawai maintains a policy of
continuous improvement and
reserves the right to change
models and specifications
without notice or liability.