AEG CCS6741ACM User Manual page 28

1
The retaining pins on the telescopic
runners must point to the front.
Install the shelf supports in the opposite
sequence.
CAUTION!
Make sure that the longer fixing wire is in
the front. The ends of the two wires must
point to the rear. Incorrect installation can
cause damage to the enamel.
12.7 Removing and cleaning the
door glasses - top oven
The door glass in your product can be
different in type and shape from the
examples you see in the image. The
number of glasses can also be different.
1. Open the door.
2. Hold the door trim on the top edge of the
door at the two sides and push inwards to
release the clip seal.
1
3. Pull the door trim to the front to remove it.
4. Remove the glass panels.
28 ENGLISH
2
1
2
To install the panels, do the same steps in
reverse.
12.8 Removing and cleaning the
door glasses - main oven
The door glass in your product can be
different in type and shape from the
example you see in the image. The
number of glasses can also be different.
1. Push the door trim at one side to remove
it.
2
1
2. Pull up the trim.
3. Remove the glass panels.
To replace the glass panels, do the same
steps in reverse. Before you lower the
trim, attach the A trim part to the door.
Refer to the image.
12.9 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven. Wait until the oven is
cold.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
A