Cisco Aironet 1540 Series Hardware Installation Manual page 55

Chapter 3 Troubleshooting
The BGN should be configured very carefully on a live network. You should always start with the most
distant access point (last node) from the RAP and move towards the RAP. If you start configuring the
BGN in a different location, then the access points beyond this point (farther away) are dropped, as they
have a different BGN.
To configure the BGN for the access points using the controller GUI, follow these steps:
Step 1
Log into your controller using a web browser.
Step 2
Click Wireless. When access points associates to the controller, the access point name appears in the AP
Name list.
Step 3
Click on an access point name.
Step 4
Find the Mesh Information section, and enter the new BGN in the Bridge Group Name field.
Step 5
Click Apply.
Step 6
Repeat Steps 2 through 5 for each access point.
Step 7
Log out from your controller, and close your web browser.
Cisco Aironet 1540 Series Outdoor Access Point Hardware Installation Guide
Changing the Bridge Group Name
3-7