Cisco Aironet 1540 Series Hardware Installation Manual page 47

Chapter 2 Installing the Access Point
Figure 2-13 Cable Gland Assembly
2
1
1
RJ45 Plug
2
Gasket
3
Clamp ring
Step 5
Insert the unterminated end of the Ethernet cable through the sealing nut-end of the cable gland (see
Figure
Step 6
Install an RJ45 connector on the unterminated end of the Ethernet cable using your Ethernet cable
installation tool.
Step 7
Carefully connect the RJ45 cable connector to the PoE port on the access point.
Step 8
Slide the cable gland with the rubber seal towards the access point, and screw the threaded end of the
body into the access point, and hand-tighten.
Step 9
Use an adjustable wrench or a 28 mm wrench to tighten the threaded end of the body into the enclosure.
Tighten to 15 lb-in.
Step 10
Use an adjustable wrench and tighten the thread-lock seal nut to 15 lb-in.
Step 11
Route your Ethernet cable, and cut off any excess cable.
Step 12
Install an RJ45 connector on the unterminated cable end, and insert it into the power injector.
Step 13
Turn on the power to the power injector.
3
2-13), and pull several inches of cable through.
Cisco Aironet 1540 Series Outdoor Access Point Hardware Installation Guide
6
5
4
4
Screw nut
5
Seal
6
Thread-lock sealing nut
Powering the Access Point
2-27