Table of Contents
Advertisement
BATTERIES: WHAT DO I NEED TO KNOW ABOUT BATTERIES?
•
Your Station comes with a CR2032 battery installed to preserve Time and History Records in
the event of a power failure. Power Cord is required to operate this station.
•
Your 868-LTV-WSDTH01 Wind/TH sensor comes with a ML2032 rechargeable battery. This
is charged by the solar panel on the front of the sensor to extend sensor life up to 3 years.
IMPORTANT:
The ML2032 battery and the CR2032 battery are not interchangeable. Using the
incorrect battery can potentially damage your sensor.
Your C80758-UK station comes with:
868-LTV-WSDTH01 Sensor with Wind Speed, Wind Direction, Temperature and Humidity
Transmission at 868MHz RF.
WHAT ARE THE POWER REQUIREMENTS FOR THIS STATION?
868-LTV-WSDTH01: 1 ML2032 battery
C80758-UK: 5 volt power cord (required) and CR2032 batteries for backup of your time and
date. Battery operation only will not update sensor or Wi-Fi data. Power cord is required.
POWER INPUT: WILL THIS STATION WORK IN OTHER COUNTRIES??
•
Your power cord input is 100-240V and may work in other countries if the proper plug
adapter is used (not included).
Note: There is no guarantee that this power cord will work in other countries.
•
This station is being sold in other countries with a slightly different model number:
o C80758
o C80758-EU
o C80758-AU
Your station is a fully functional standalone station.
1. Remove the Isolation Tab from the 868-LTV-WSDTH01 sensor and turn the switch to ON.
2. Install power cord into wall outlet, and into the station. Remove the insulation tab from the
CR2032 battery in you station.
3. Let sensor and station sit within 10 feet of each other for several minutes to lock the sensor
signal to the display.
HARDWARE: SENSORS AND STATION
SETUP AND MOUNTING
SETUP: HOW DO I SETUP MY STATION?
4 |
P a g e
Advertisement
Table of Contents
