Table of Contents
Advertisement
Operating instruccions Peristaltic Pumps
8.
ASSEMBLY, COMISSIONING AND INSTALLATION
8.1.
Ambient conditions
Assembly is to be carried out in the following order.
If the pump has to be installed outdoors, then it is to be equipped with protection against
sunlight and weather influences.
When positioning the pump, ensure that sufficient room for access is provided for all types
of maintenance work.
Limit values for hose temperature and pressure.
Min. Temp. (°C)
Hose Material
Feed chemical
NR
NBR
NBR-A
EPDM
CSM
* At max. temperature, the life of hose is drastically reduced.
Please contact BOYSER for applications with feed chemical temperature higher than 60°.
8.2.
Commissioning
8.2.1. Testing prior to commissioning the pump
The following tests are to be carried out:
- Check that the shoes are correctly fitted and fastened.
- Check that the drive and the pump housing are properly lubricated. The specially
formulated lubricant can be obtained from BOYSER or from the authorized distri-
butor.
- Only switch the pump on if the front cover has been properly attached.
- Check that the mains voltage is suitable for the motor.
- Check that the thermal overload protection (not included in the delivery scope)
corresponds to the value specified on the motor type plate.
- Confirm that pump has been properly earthed.
- Connect the electric motor according to local applicable rules and regulations.
The electrical installation work must be carried out by qualified personnel.
- Check that the optional electrical components are connected and are working
properly.
- Check whether the direction of rotation is correctly adjusted.
RBT Series
Max. Temp (°C)
Feed chemical
- 10
80*
- 10
80*
- 10
80*
- 10
80*
- 10
80*
12
Min. Temp (°C)
Max. Pressure
Environment
- 20
- 20
- 20
- 20
- 20
(bar)
15
15
15
15
15
Advertisement
Table of Contents
