Watchguard AP430CR Hardware Manual page 8

LED Color Status
Flashing Red WatchGuard
or Orange Cloud device
(Medium: 500 registration
milliseconds)
Flashing Red Connection to
or Orange WatchGuard
(Slow: 2 Cloud servers
seconds)
Solid Blue Successfully
connected to
WatchGuard
Cloud
Flashing Blue Flash LED action
from WatchGuard
Cloud
Flashing Blue Access point failed
and Red system integrity
check
Troubleshooting
If you set up an access point behind a firewall that performs
inspection on HTTPS traffic, you must add *.watchguard.io to
the content inspection exception / bypass list to enable the
access point to receive a feature key from WatchGuard servers.
On the WatchGuard Firebox, this is enabled by default for cloud-
managed Fireboxes in WatchGuard Cloud.
Use the access point Web UI or command line interface (CLI) to
check the feature key status, download a feature key, and run
diagnostic tests. For more information, go to
UI or Access Point Command Line
If the access point remains in this state:
Make sure access point can connect to *.watchguard.com for
WatchGuard Cloud device registration.
For service providers, make sure you have allocated the access
point from your inventory to a subscriber account. For more
information, see Access Point
Make sure you have added the access point to your WatchGuard
Cloud subscriber account. For more information, see
Access Point to WatchGuard Cloud
If the access point remains in this state:
Make sure the access point can connect to *.watchguard.com
for WatchGuard Cloud management connections and is not
blocked by a firewall or other network device.
Make sure you do not have an expired MSSP license for the
access point.
Check the access point allocation status to see whether the
device was deallocated from the subscriber account.
Device is online and connected to WatchGuard Cloud.
LED flashes blue for 60 seconds for identification.
If the device LEDs flash alternating blue and red every second, the
device has failed a system integrity check and has rebooted in failsafe
mode. You must contact WatchGuard Support to replace the device.
Access Point Web
Interface.
Allocation.
Add an