Table of Contents
Advertisement
TO PLAY ONLY DESIRED TRACKS/DISCS
| Programming a pause
| To check the program contents
Inserting a pause in your program can be very useful when carrying
out recording. Press PAUSE instead of entering a track number.
"PA" appears on the display panel,
@
For example, when recording on both sides of a cassette tape.
if you program a pause after the last track to be recorded on
the first side, program
playback will pause at that point to
allow you to switch tape sides. To resume program playback
after the player enters pause mode, press PAUSE.
Notes:
@
Apause can be programmed only when the program procedure
is performed under stop mode.
@
A pause cannot be programmed at the beginning of a program
(P-01), and two pauses cannot be programmed one after the
other.
@
Apause inserted in a program is counted as one step.
®
if a pause is programmed as the last step of a program, the
player will not enter the pause mode.
To clear all of the program contents
®:
=a
47
(OF
a al
a
®
During stop mode, press STOP/CLEAR.
@® When the magazine is ejected, the program contents will be
cleared.
To erase a program
|
CLEAR
CLEAR
dA 7
During program mode, press CLEAR on the remote contro! unit.
The fast program step is erased and the contents of the previous
program step are displayed.
NOTE:
2
Contents of a program can be erased during playback as well.
However,
tracks preceding the currently playing track cannot be
erased in this way.
14
<PRB1123>
En
During program
mode, set the player to stop mode and press
CHECK on the remote control unit. The program contents will be
displayed in the programmed order.
e@
After confirming the last program step, the display will show
"0-00".
To modify the program contents
1
(3
ES
ia »)
7 I
@@
il
u
~
[asta]
1. Press CHECK so that the program step to be corrected appears
on the display.
2. To correct the disc No., enter the new disc No. with the DISC
NUMBER
buttons.
To correct the track No., enter the new
track No. with the Track number/Digit buttons. For example,
the programmed track No. 4 on the disc No. 3 is changed to
track No. 7 on the disc No. 5, using the DISC NUMBER 5 and
Track number 7 buttons.
e@ Repeat steps 1 and 2 to change other tracks as desired.
Advertisement
Table of Contents
