Table of Contents
Advertisement
Open the lid.
2.
Pour liquid detergent
3.
softener
into the relevant dis-
pensers → Page 19.
Do not exceed the marking for the
maximum fill level when filling.
Note: You can also use both dis-
pensers for liquid detergent. Adapt
the dispenser for this. → Page 37
Close the lid.
4.
Note: To prevent the liquid deter-
gent or fabric softener from drying
out, close the lids immediately
after filling.
Push in the detergent drawer.
5.
16.2 Using the manual dosing
compartment
If you are not using the intelligent
dosing system, if intelligent dosing is
not possible for a programme, or if
and fabric
Intelligent dosing system en
you want to add additional care
product, e.g. stain remover or starch,
use the manual dosing compartment.
Note: Observe the information about
detergents and care products
→ Page 32.
Pull out the detergent drawer.
1.
Pour laundry detergent or care
2.
product into the manual dosing
compartment → Page 19.
Push in the detergent drawer.
3.
16.3 Adapting the / dis-
penser
The
/ dispenser can dose fabric
softener
or liquid detergent .
When it leaves the factory, the dis-
penser is set for fabric softener. If
you want to automatically dose a
second liquid detergent, adapt the
dispenser.
Notes
¡ If you adapt the contents of the
dispenser, the basic dosage for
this dispenser is reset.
¡ If you use both dispensers for li-
quid detergent, you must set a dis-
penser which is to be used during
washing.
→ "Buttons", Page 25
Press and hold i-DOS 2 for approx.
1.
3 seconds.
Press i-DOS 2 repeatedly until the
2.
display shows
or
(fabric softener).
Wait briefly to save the setting.
3.
16.4 Setting the basic dosage
amount
To allow for intelligent dosing, set the
basic dosage amount for the dis-
penser. The basic dosage amount
corresponds to the dosage recom-
mendation from the detergent manu-
(liquid detergent)
37
Advertisement
Table of Contents
