Table of Contents
Advertisement
en Installation and connection
WARNING
Risk of injury!
When using the appliance on a base,
the appliance may tip over.
Always secure the feet of the appli-
▶
ance to a base using the manufac-
turer's fixing brackets → Page 32
before using the appliance for the
first time.
ATTENTION!
If residual water in the appliance
freezes, this may cause damage to
the appliance.
Do not install or operate this appli-
▶
ance anywhere that is liable to ex-
perience frost or outdoors.
If the appliance is tilted at an angle
greater than 40°, residual water may
leak out of the appliance and cause
material damage.
Tilt the appliance carefully.
▶
Transport the appliance in an up-
▶
right position.
Installation loca-
tion
Base
Wooden joist
floor
14
Requirements
Secure the appli-
ance with fixing
brackets
→ Page 32.
Place the appli-
ance on a water-
resistant wooden
board (minimum
thickness of
30 mm) which is
screwed tightly to
the floor.
Installation loca-
tion
Kitchen unit
Against a wall
4.4 Removing the transit
bolts
The appliance is secured for trans-
portation using transit bolts on the
rear of the appliance.
Note: Keep the transit bolt screws
and the sleeves in a safe place for fu-
ture transport.
→ "Inserting the transit bolts",
Page 59
Pull the hoses out of the holders.
1.
Requirements
Only install the
appliance under-
neath a continu-
ous worktop that
is securely con-
nected to adja-
cent cabinets.
Required niche
width: 60 cm.
Do not trap the
power cord or
the hoses
between the wall
and the appli-
ance.
Advertisement
Table of Contents
