Table of Contents
Advertisement
en Troubleshooting
Fault
Loud noises during
the spin cycle.
Banging noises, rat-
tling in the drain
pump.
Slurping, rhythmical
suction noise.
Fan noise during the
washing phase.
Longer, whirring noise
before the start of the
wash cycle or fabric
softening.
Brief whirring noise
after switching on the
appliance.
Spin noise during the
drying phase.
Rushing, hissing
noise.
Water inlet noise dur-
ing the drying phase.
Odours have formed
in the appliance.
58
Cause and troubleshooting
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 16
▶
The appliance feet are not fixed.
Secure the appliance feet.
▶
→ "Aligning the appliance", Page 16
Transit bolts have not been removed.
→ "Removing the transit bolts", Page 14.
▶
Foreign bodies have got into the drain pump.
→ "Cleaning the drain pump", Page 43
▶
The drain pump is active, the detergent solution is
pumped out.
Not a fault – normal operating noise.
▶
Process fan is active.
Not a fault – normal operating noise.
▶
Intelligent dosing system dispenses detergent or care
products.
Not a fault – normal operating noise.
▶
Intelligent dosing system carries out a function test.
Not a fault – normal operating noise.
▶
Thermal spinning is active.
Not a fault – normal operating noise.
▶
Water is flushed under pressure into the detergent
drawer.
Not a fault – normal operating noise.
▶
Drying phase requires water.
Not a fault.
1.
Make sure that the water tap also remains open
2.
during the drying phase.
Humidity and detergent residue may promote the
formation of bacteria.
→ "Cleaning the drum", Page 41
▶
If you are not using the appliance, leave the door
▶
and detergent drawer open so that residual water
can evaporate.
Advertisement
Table of Contents
