Setting up cable box control
(continued)
38
| Getting Started
To ensure correct operation
e Position the cable box/DSS receiver away from the VCR.
* Point the remote commander at the VCR, not at the cable box/DSS
receiver.
Side view
eas; Signal flow
To check the cable box control setting
receiver
¢ Check that the Cable Mouse is connected to the CABLE BOX
CONTROL jack on the VCR.
¢ Check the position of the Cable Mouse.
* Try the setup again making sure to use the correct control code. If the
cable box still does not respond, try the other codes that are listed.
If your cable box still does not operate with the Cable Mouse, contact
your cable company to see if they can provide you with a compatible
cable box.
Note
¢ Make sure you turn off the VCR when you plug in or unplug the Cable Mouse. If
you unplug the Cable Mouse and plug it in again, turn on the VCR before you use
the cable box/DSS receiver control feature.