Sony SLV-AV100U Operating Instructions Manual page 26

Step 5
Hookup 5: VCR setup
1 Set the RF UNIT switch to CH 3 or CH4, whichever
channel is not used in your area. If both are used,
set the switch to either channel.
For details, see page 92. If you made V connection
(from page 12), you can skip this step.
: RF UNIT
CH3:
CH4
2 Turnon your DSS receiver.
3 Press EASY SET UP on the VCR.
@ The CLOCK SET menu appears. Set the date and time
and press EXECUTE. For details, see page 33.
7/1/1997 WED 12:00M
SELECT : [#4
SET : [e#
NEXT : [EXECUTE
© The CABLE BOX CONTROL menu appears.
Select ON. For details, see page 35.
CABLE BOX CONTROL aes
CABLE MOUSE
BOX OUTPUT CH
© Enter your DSS receiver code number and press
CURSOR.
For details, see page 35.
> [EXECUTE]
26 Getting Started
TV antenna or cable hookups (continued)
© Set your DSS receiver output channel (BOX OUTPUT
CH) to LINE and press EXECUTE.
ET ut paaet a e s
CABLE BOX CONTROL
CABLE MOUSE
BOX CODE NO.
BOx OUTPUT CH
SELECT :
SET :
: feo
NEXT : (EXECUTE)
@ The CENTER MODE selection menu appears.
Select the center mode and press EXECUTE.
For details, see page 30.
© The TEST TONE selection menu appears.
Set the volume of the center and rear speakers and
press EXECUTE.
For details, see page 31.
[TEST TONE |
)} {ine fp
: fea] SET : [#9]
: (EXECUTE)
SET UP is done
Normal display
Notes
To successfully record a program from the DSS receiver, proceed
as follows: -
¢ Leave the DSS receiver on all the time.
¢ Turn off the display (menu screen, channel number, etc.) of the
DSS receiver. 2
¢ To record or receive locked channels, unlock the channel before
the VCR starts recording.
¢ To set pay-per-view programs in the timer setting, order the
pay-per-view program before the VCR starts recording.
e Some programs are copy protected. You cannot record these
programs.