Connection Of External Controls And Accessories; Manual Unlocking - Schartec Prime 2 Series Installation And Operation Manual

Connection of external controls and accessories

1. Der O/S/C connection: Connect an external push-button or key-switch to the door opener.
2. Photocell Connection: The connection of a photocell increases the safety during the operation of your garage door opener. NOTE: The
Schartec Prime garage door opener can ONLY be used with the Schartec PLS1 photocell!!!
3. Warning light connection: This connection is suitable for the following warning lights: 24-35V DC, max. 12 Watt, max. 500 mA.
4. Wicket door contact connection: This function prevents the garage door from opening when the wicket door in the door leaf is open, thus
5. preventing damage to the door. IMPORTANT! Remove the jumper in the terminal strip when using a wicket door contact. And be sure to
check the function before use.
PB GND PH +24V
O/S/C
Push-Button/
Key-Switch
Fig. 14
PB GND
Fastening the warning sign
Attach the anti-trap warning sign permanently to a conspicuous, cleaned and degreased location, for example near the permanently installed
button for operating the opener.
The garage door opener is equipped with a manual release. This allows the garage door to be opened and closed manually when the cable is pulled
down. To unlock, simply pull the cord. To re-engage, simply open the door opener automatically or move the door by hand until the carriage is
re-engaged with the chain/timing belt.
+35V GND DOOR
PH +24V +35V GND DOOR
Signal Lamp
24-35V DC
Max. 500 mA
Fig. 16

Manual unlocking

PB GND PH +24V
TX
Photocell Connection
Only usable with Schartec PLS1 photocell!!
The terminals coming from RX and TX can be interchangeably connected to the PH and GND terminals.
Fig. 15
PB GND
30
+35V GND DOOR
RX
PH +24V +35V GND DOOR
Wicket (pass)
Door
Fig. 17