Start-Up Procedure - Yoto Lion Owner's Manual

Start-Up Procedure

After the bike has been properly assembled if all components are secured correctly, and you have read this entire manual, you
may turn the bike on and select a power level following the steps outlined below:
NOTICE: 1. Ensure the key port is aligned in the "lock" position.
2. Ensure proper handlebar and seat adjustment of the bike to the rider.
3. Ensure the handlebar faceplate bolts and seatpost quick release are fully and properly secured.
4. Make sure the throttle is back to its original position.
◆
Turn on the bike
①Then long press the "M" button to turn on the display.
②Turn on the headlight, press and hold the UP arrow for 3 seconds
◆
Select the desired level of pedal assistance
(PAS) between level 0 through 5 using the up and down arrows on the display remote. Level 1 corresponds to the lowest level of pedal assistance, and
level 5 corresponds to the highest level of pedal assistance. Level 0 indicates pedal assistance is inactive. Start in PAS level 0 or 1 and adjust from there.
◆
Begin riding carefully
With the proper safety gear and rider knowledge, press the red button and you may now operate your bike from Yoto Bikes. On a flat surface, in a low
gear (1 or 2), most riders should be able to begin pedaling the bike with pedal assist level 0 or 1. You may also use the throttle to accelerate and maintain
your desired speed.
17