Table of Contents
Advertisement
tamper button is activated.
Enable or disable the light indicating in chapter 2.3.
LED Indicator
Note:
Change Password
Change the password for ToolBox App to write this device.
3.4 Milesight D2D Settings
Milesight D2D protocol is developed by Milesight and used for setting up transmission among
Milesight devices without gateway. When the Milesight D2D setting is enabled, WS301 can work
as a Milesight D2D controller to send control commands to trigger Milesight D2D agent devices.
1. Configure RX2 datarate and RX2 frequency in LoRaWAN
the default value if there are many LoRaWAN
2. Go to Device > Settings > D2D Settings to enable D2D function, and define an unique
Milesight D2D key which is the same as Milesight D2D agent devices, then select the fr
equency and spreading factor. (Default Milesight D2D Key: 5572404C696E6B4C6F5261323
0313823)
3. Enable one of WS301 status and configure a 2-byte hexadecimal command (This command
is pre-defined in Milesight D2D agent device). When WS301 detects this status, it will send the
control command to corresponding Milesight D2D agent devices.
Note:
If you enable LoRa Uplink feature, LoRaWAN
magnet status will be sent to gateway after the Milesight D2D control command is sent.
The indicator of reset button is not allowed to disable.
devices around.
®
settings, it is suggested to change
®
uplink packet that contains the sensor's
®
11
Advertisement
Table of Contents
