Table of Contents
Advertisement
3. Operation Guide
3.1 NFC Configuration
IOT-S500DCS can be configured via a NFC supported mobile phone.
1. Pull out the battery insulating sheet to power on the device. The indicator will light up in green for 3
seconds when device turns on.
2. Download and install "ToolBox" App from Google Play or Apple Store.3.
Enable NFC on the smartphone and open Milesight ToolBox.
4. Attach the smartphone with NFC area to the device to read device information.
5. Basic information and settings of devices will be shown on ToolBox if it's recognized
successfully. You can read and configure the device by tapping the Read/Write button on the
App. In order to protect the security of devices, password validation is required when first
configuration. The default password is 123456.
Note:
1) Ensure the location of smartphone NFC area and it's recommended to take off phone case.
2) If the smartphone fails to read/write configurations via NFC, keep the phone away and back to try again.
3) IOT-S500DCS can also be configured by ToolBox software via a dedicated NFC reader provided by IoT,
you can also configure it via TTL interface inside the device.
7
Advertisement
Table of Contents
