Vehicle Operation - CrimeStopper RS900 Operating Instructions Manual

and 4 flashes for the 4
otherwise turn key off and close hood. See diagram below.
TRANSMITTER PROGRAMMING:
(GRAY WIRE GROUNDED)
The RS-900 V system can be used for 2 car operation. A single RS900V remote can control two independent vehicles
with RS900 V systems installed.
SETUP:
See diagram below on how to switch your remote to car 2 operation. Once you switched your remote to Car 2, then
follow the transmitter programming steps AT VEHICLE #2 and learn YOUR remote, along with Car 2's existing remotes.
Transmitter programming steps are listed on page 10. This type of 2-Vehicle operation can only be performed with the
CS-396 transmitter that includes a slide switch on the side of the remote for Car I or Car II operation.
th
code. If all 4 codes are learned, the unit will automatically exit code learning mode,
OFF
START
FLASH 2, 3, or 4 X's
RS900 V

2-VEHICLE OPERATION

IGN
PRESS 4X's
OFF
WAIT FOR
4 FLASHES
IGN