Factory Default Parameter - Ebyte E220-900T30D User Manual

CU Chengdu Ebyte Electronic Technology Co., Ltd. E220-900T30D User Manual
it will be issued forcibly when it reaches 2
seconds.
3 Reserve
2 1 0 | WOR Cycle
0 0 0 500ms Only valid for mode 1,
0 0 1 | 1000ms Cycle T= (1+WOR)*500ms, the maximum is
0 1 0 1500ms 4000ms, the minimum is 500ms;
0 1 1 2000ms The longer the WOR monitoring interval period,
1 0 0 | 2500ms the lower the average power consumption, but the
greater the data delay;
1 0 1 | 3000ms
Both transmitter and receiver must agree (very
1 1 0 | 3500ms important)
1 1 1 | 4000ms
} CRYPT } 'Write only, read returns 0,
06H Write H Key high byte (default 0) Used for encryption to avoid interception of
— wireless data in the air by similar modules;
The module will use these two bytes as a
. CRYPT . .
07H Write L Key low byte (default 0) calculation factor to transform and encrypt the air
wireless signal.
7.3 Factory Default Parameter
Table 7-3 Default parameters
Model Factory default parameter; c0 00 00 62 00 17
Module No. Frequency Address Channel Air data rate Baud rate Serial format Power
E220-900T30D 873.125MHz 0x0000 0x17 2 4kbps 9600 8N1 30dbm
Copyright ©2012-2020, Chengdu Ebyte Electronic Technology Co.,Ltd. 16