Page 4
Chengdu Ebyte Electronic Technology Co., Ltd. E22-400T30D User Manual 13 E22 SERIES ..........................22 14 ANTENNA RECOMMENDATION ..................23 15 PACKAGE FOR BATCH ORDER .................... 24 ABOUT US ............................24...
1. Overview 1.1 Introduction E22-400T30D is new lora module (UART) based on SEMTECH's SX1268 RF chip. It has multiple transmission modes working at 410.125~ 493.125MHz, LoRa spread spectrum technology, TTL level output, compatible with 3.3V and 5V IO port voltage.
Chengdu Ebyte Electronic Technology Co., Ltd. E22-400T30D User Manual Industrial grade standard design, support -40 ~ 85 °C for working over a long time; SMA-K interface for external antenna. 1.3 Application Home security alarm and remote keyless entry;...
Page 7
Chengdu Ebyte Electronic Technology Co., Ltd. E22-400T30D User Manual Operating temperature(℃) Industrial design Operating frequency(MHz) 410.125 493.125 Support ISM band Power TX current(mA) Instant power consumption consumpti RX current(mA) Sleep current(uA) Software is shut down 29.5 30.0 30.5 Max Tx power(dBm)...
Chengdu Ebyte Electronic Technology Co., Ltd. E22-400T30D User Manual 3 Size and pin definition Name Direction Function Input Work with M1 to decide 4 working modes of module (not suspended, if not (weak pull-up) used, could be grounded). Input Work with M0 to decide 4 working modes of module (not suspended, if not (weak pull-up)...
Chengdu Ebyte Electronic Technology Co., Ltd. E22-400T30D User Manual 5 Function description 5.1 Fixed transmission 5.2 Broadcasting transmission 5.3 Broadcasting address For example: Set the address of module A as 0xFFFF or 0x0000, and the channel as 0x04; When module is the transmitter (transparent transmission), all modules under channel 0x04 will receive the data, the purpose of ...
Chengdu Ebyte Electronic Technology Co., Ltd. E22-400T30D User Manual broadcast is realized. 5.4 Monitor address For example: Set the address of module A as 0xFFFF or 0x0000, and the channel as 0x04; When module A is the receiver, it can receive the data sent from all modules under channel 0x04, the purpose of monitor is ...
Chengdu Ebyte Electronic Technology Co., Ltd. E22-400T30D User Manual 5.6.2 Indication of wireless transmitting Buffer (empty): the internal 1000 bytes data in the buffer are written to the RFIC (Auto sub-packaging). When AUX=1, the user can input data less than 1000 bytes continuously without overflow. Buffer (not empty): when AUX=0, the internal 1000 bytes data in the buffer have not been written to the RFIC completely.
Chengdu Ebyte Electronic Technology Co., Ltd. E22-400T30D User Manual When the user switches to other operating modes from mode 3 (sleep mode) or it’s still in reset process, the module will reset user parameters, during which AUX outputs low level.
Chengdu Ebyte Electronic Technology Co., Ltd. E22-400T30D User Manual Similarly, any mode switching can use this feature. After the module processes the current mode event, it will automatically enter the new mode within 1ms; thus eliminating the need for the user to query AUX and achieve the purpose of fast switching;...
Chengdu Ebyte Electronic Technology Co., Ltd. E22-400T30D User Manual 6.5 Deep sleep mode(Mode 3) Type M0 = 1,M1 = 1 Transmitting Unable to transmit wireless data Receiving Unable to receive wireless data When from the sleep mode to other modes, the module will reconfigure the parameters. During the configuration process, Note AUX will remain low;...
Chengdu Ebyte Electronic Technology Co., Ltd. E22-400T30D User Manual E.g 2: Configure module address (0x1234), network address (0x00), serial port (9600 8N1) and air data rate (1.2K). Send: C2 00 04 12 34 00 61 Return: C1 00 04 12 34 00 61 Command: CF CF + normal command Respond:CF CF + normal respond...
Page 17
Chengdu Ebyte Electronic Technology Co., Ltd. E22-400T30D User Manual 100: 9.6k 101: 19.2k 110: 38.4k 111: 62.5k When the data is smaller than the sub packet length, 7,6: Sub packet setting the serial output of the receiving end is an uninterrupted continuous output.
Chengdu Ebyte Electronic Technology Co., Ltd. E22-400T30D User Manual --------------------------------------- 1:Fixed point transmission mode After the reply function is enabled, if the target 0 : Transparent transmission mode address is not the module itself, the module will forward it once.
Chengdu Ebyte Electronic Technology Co., Ltd. E22-400T30D User Manual Model No. Frequency Address Channel Air data rate Baud rate Parity format Power E22-400T30D 433MHz 0x0000 0x17 2.4kbps 9600 30dBm 8 Repeater networking mode Description After setting the repeater mode by configuration, switch to the normal mode and the repeater starts working.
Chengdu Ebyte Electronic Technology Co., Ltd. E22-400T30D User Manual 9 Configuration instructions on computer The following figure shows the E22-400T30D configuration host computer display interface, the user can switch to the command mode through M0M1, and quickly configure and read the parameters on computer.
Chengdu Ebyte Electronic Technology Co., Ltd. E22-400T30D User Manual Frequency channel: 0-83 Network ID: 0-255 Key: 0-65535 When the user configures the repeater mode using the host computer, special attention must be paid. Since the parameters are in decimal mode in the host computer, the module address and network ID need to be converted into hexadecimal. For example, if the network ID input by the transmitting end A is 02, and the network ID input by the receiving end B is 10, when the repeater end R sets the module address, the hexadecimal value 0X020A is converted into the decimal value 522 as the repeater end R.
Chengdu Ebyte Electronic Technology Co., Ltd. E22-400T30D User Manual can be done. If the communication line uses a 5V level, a 1k-5.1k resistor must be connected in series (not recommended, there is still a risk of damage); Try to stay away from some physical layers such as TTL protocol at 2.4GHz , for example: USB3.0;...
Chengdu Ebyte Electronic Technology Co., Ltd. E22-400T30D User Manual Solder Paste Solder paste Sn63/Pb37 Sn96.5/Ag3/Cu0.5 Preheat Temperature min (Tsmin) Min preheating temp. 100℃ 150℃ Preheat temperature max (Tsmax) Mx preheating temp. 150℃ 200℃ Preheat Time (Tsmin to Tsmax)(ts) Preheating time...
About us Technical support: support@cdebyte.com Documents and RF Setting download link: www.ebyte.com Thank you for using Ebyte products! Please contact us with any questions or suggestions: info@cdebyte.com ------------------------------------------------------------------------------------------------------------ Web: www.ebyte.com Address: Building B5, Mould Industrial Park, 199# Xiqu Ave, West High-tech Zone, Chengdu, 611731, Sichuan, China...