Raspberry Pi 3B User Manual page 4

FCC
Raspberry Pi 3B FCC ID: 2ABCB-RPI32
This device complies with Part 15 of FCC Rules,
Operation is Subject to following two conditions:
l.
This device may not cause harmful interference.
2. This device must accept any interference
received including interference that cause
undesired operation.
CAUTION
Any changes or modifications to the equipment not
expressly approved by the party responsible for
compliance could void users authority to operate
the equipment. This equipment has been tested
and found to comply within the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used
m accordance with the instructions, may cause
harmful interference to radio commumcations.
However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and on, the
user is encouraged to try to correct the interference
by one or more of the following measures:
Re-orient or relocate the receiving antenna
increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a
different circuit from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV
technician for help.
For products available on the USA/Canada market,
only channels 1 to 11 are available for 2.4GHz WLAN.
This device and its antenna(s) must not be co-located
or operation in conjunction with any other antenna
or transmitter except in accordance with FCC's
multi-transmitter procedures.
IMPORTANT NOTE
FCC Radiation Exposure Statement; Co-location of
this module with other transmitter that operate
simultaneously are required to be evaluated using
the FCC multi-transmitter procedures.
This device complies with FCC RF radiation exposure
limits set forth for an uncontrolled environment. The
device contains an integral antenna hence, the device
must be installed to so that a separation distance of at
least 20cm from all persons.
ISED
Raspberry Pi 3B IC: 20953-RPl32
This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause interference.
2. This device must accept any interference,
including interference that may cause undesired
operation of the device.
Le present appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisee aux
deux conditions suivantes:
L L'appareil ne doit pas produire de brouillage,
2. L'utilisateur de l'appareil doit accepter tout
brouillage radioelectrique subi, meme si le
brouillage est susceptible d'en compromettre le
fonctionnement.
For products available on the USA/Canada market,
only channels 1 to 11 are available for 2.4GHz WLAN
Selection of other channels is not possible.
Pour les produits disponibles sur le marche USA
I Canada, seuls les canaux 1 a 11 sont disponibles
pour le reseau local sans fil 2,4 GHz. La selection
d'autres canaux n'est pas possible.
This device and its antenna(s) must not be co-located
with any other transmitters except in accordance
with IC multi-transmitter product procedures.
Cet appareil et son antenne (s) ne doit pas etre
co-localises ou fonctionnement en association avec
une autre antenne ou transmetteur.
IMPORTANT NOTE
IC RADIATION EXPOSURE STATEMENT
This equipment complies with IC RSS-102 radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed
and operated with minimum separation distance of
20cm between the device and all persons.
Cet equipement est confonne aux limites
d'exposition au rayonnement IC RSS-102 defmies
pour un environnement non contr61e. Cet
equipement doit etre installe et utilise avec une
distance de separation minimale de 20 cm entre
l'appareil et toutes les personnes.
SPAIN
LA OPERACI6N DE ESTE IEQUIPO ESTA SUJETA A
LAS SIGUIENTES DOS CONDICIONES
1. Es posible que este equipo o dispositivo no cause
interferencia perjudicial.
2. Este equipo o dispositivo debe aceptar cualquier
interferencia. Incluyendo la que pueda causar su
operaci6n no deseada.
AUSTRALIA AND NEW ZEALAND
CLASS B EMISSIONS COMPLIANCE STATEMENT
WARNING
This is a Class B product. In a domestic
environment this product may cause radio
interference in which case the user may be
required to take adequate measures.
~
[]] 205-160251
~
KCC: MSIP-CMM-P2R-RPl32
Aft\Xf \'fLHli' Ol717IE \j.'f-% :<g'30JIAj Af%Y "\"\<::>£
~gr~~7f~
igg
717!£.A.i 7r~~ .@!--?30JIAi Ar-§OfE
?3-9--{fIIf[l-{;1£1 if-2.97f VELJq.~ 7171-E ~{," OI-§
{{EH21 ""' \'Jtil(Di"I,
l'l~)2f
20cm
"'"'r"le 7jiOIOJIAi
Af%5CIOjO~ filLlq. ~LHt!%
CMllT ID: 2016DJ0710
Q
ANATEL
04908-17-1 0629
UK
C:R
CE
F©:
I
~~Sii
TA-2016/623
.Sl
APPROVED
Certified
for use in Hong Kong
~~mCJi':Efil~riem
Certificate No.
~~Mm~
HK0002160004
7
im'1\il<l!U1l!il1il
COMMUNICATIONS
AUTHORITY
1-(((
CCAJ-1 6LP3S9-0T1
J
)?!
......
NTC
i)g)
Type Approved
' i c<J
No.: ESD-171 5736C
~
~
Hii:lml'"
&
The Adopted Trademarks HDMI, HDMI High-
Definition Multimedia Interface, and
th~
HDMI Logo
are trademarks or registered trademarks of HDMI
Licensing Administrator, Inc. in the United States
and other countries." OR "The terms HDMI, HDMI
High-Definition Multimedia Interface, and the HDMI
Logo are trademarks or registered trademarks of
HDMI Licensing Administrator, Inc.