Maytag SAV-4 HD Use & Care Manual page 11

Troubleshooting
Fills with the Wrong
Temperature Water
Cycle Selector
Advances Through Off
• Turn both faucets on fully.
• If equipped with a temperature selector knob, be sure it is set directly on a
temperature setting and not between settings.
• Make sure temperature selection is correct.
• While the washer is filling, you may notice just hot and/or just cold water entering
the tub when cold or warm wash temperatures are selected. This is a normal
function of the automatic temperature control feature as the washer determines the
temperature of the water.
• If Auto Temperature Control (select models) is selected, cold water may feel warmer
than cold water from the tap. (See page 4).
• Make sure hoses are connected to correct faucets and inlet connections. Be sure
water supply is regulated correctly. Flush water line before filling washer.
• Check the water heater. It should be set to deliver a minimum 120 ° F (49 ° C) hot
water at the tap. Also check water heater capacity and recovery rate.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• Extra Rinse (select models) is selected.
10