Yale Assure Lock 2 Plus Manual page 22

9c
DoorSense Flush Mount
1. Take off DoorSense cover.
2. Push the magnet out of the housing.
3. Expose the adhesive on the magnet cap by removing the blue backing.
4. Press the magnet onto the cap so that the notches interlock.
5. Determine mounting location on the door frame. The distance from the
center of the strike plate to the center of the DoorSense should be 2",
making the DoorSense in line with the logo on the battery cover of the lock.
6. Mark a hole that's horizontally centered on the door frame and is 5/8" in
diameter.
7. Drill a 1/2" deep hole where marked.
8. Insert DoorSense into the hole.
Note: If it is too snug to push in by hand, protect the frame with a piece of scrap wood
and use light blows with a hammer or mallet. If it is too loose, try wrapping tape around
it so that it fits snugly.
1
3
4
P/N YRD450-N-MNL-0039 Rev A
2
Frame
7
5
2"
22
5/8"
6
8