Cisco Catalyst 8300 Series Hardware Installation Manual page 10

Status Indicators and LEDs for Gigabit Ethernet Ports
LED Definition
GE0-2 RJ45 Activity LED
GE0-2 RJ45 Link LED
SFP+ 0-3 Link LED
BMC Management port Activity
LED
BMC Management port Link LED
LED Definition
PWR (1 LED)
STATUS (1 LED)
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
6
Color
G
G
G/Y
G
G
Color
R/Y LED1
R/G/Y LED2
Overview of Cisco Catalyst 8300 Series Edge uCPE
Description
Ethernet port 0/1/2 Activity LED
Off: No Activity Blinking Green :
Ethernet Activity Detected
Ethernet port 0/1/2 Link LED
Off: No link Green: Ethernet cable
present and link established with
other side
SFP+ port 0/1/2/3 Link LED Off:
Not present or not configured
Yellow : Loss of Signal Green:
Green: Link established
BMC Management Ethernet
Activity LED Off: No Activity
Blinking Green : Activity
BMC Management Ethernet
Link LED Off: No link Green:
Ethernet cable present and link
established with other side
Description
Power supply status LED Off:
The system is powered off Amber
(Green + Red) : A PSU in system
is not functioning correctly Green:
All installed PSUs are operating
correctly
Status LED GREEN - x86 booted
fine AMBER - x86 in rommon
mode (setup menu) RED blinking
— x86 Secure boot failure RED -
x86 is UP but BIOS is not fully UP
yet (bios post cmplt not set) OFF -
x86 in power-off state