Assa Abloy ES8100 Installation Manual And User's Manual page 7

PtL
PtL
The lock is supplied with the indication LED activated and illuminating red when secure.
To activate or de-activate the indication LED:
Supply the lock with power through USB or main connector.
Carefully press and hold the push button for 3 seconds.
The lock will enter setup mode and the LED will illuminate white.
Short press the button to select illumination colour or deselect LED activation.
The lock will cycle through the LED indication table with each short press and
display the secure illumination colour for 1s to indicate setting change.
Press the button for 3 seconds to exit setup mode. The LEDs will no longer illuminate
white and will begin to illuminate according to power supplied and lock status.
The setup mode will time-out after 60s and setting will not be saved.
Push button located
under the slide switch.
Adjust the slide switch at the rear of the lock to select
locking function.
PtO ~ Power to Open or Fail Secure
PtO
PtL ~ Power to Lock or Fail Safe
PtO
For lock function setting changes to take effect, the lock has to be
completely powered down (approx. 2 minutes without power).
The new setting will be active when the lock is next powered.
SETTING LOCK FUNCTION
Lock shown in PtL setting
Lock is supplied in PtL setting
SETTING INDICATION LED
LED indication table
Lock secure Lock open
RED GREEN
GREEN RED
OFF OFF
Indication LED
1s display
RED (default)
GREEN
PURPLE