Wali M12XXL Installation Manual

INSTALLATION MANUAL
Dual Monitor Desk Mount
M12XXL
Supplied Parts List
Lower Pole Middle Pole Upper Pole
A1 (x1) B2 (x1) C3 (x1)
Nut M4x12 Bolt M4x30 Bolt
E (x2) F (x8) G (x8)
2
Option A : Clamp Installation
1. Connect Lower Pole a and C-Clamp Brace c from the bottom using M5x14 Bolt f and tighten with Allen Key 3mm o . A1
B2
J1
I
www.walielectric.com
support@walielectric.com
1-844-SATTLER (18447288537)
C-Clamp C-Clamp Brace Support Plate
B1 (x1) B2 (x1) B3 (x1)
M4~M6 Spacer Allen Key M5x14 Bolt
H (x8) I (x1) J1 (x3)
J1
I
A1
B2
WARNING
！
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect
assembly or inappropriate use.
TIPOVER WARNING
！
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
● NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR STAND.
● USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL.
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
M10 Hand Knob Grommet Base Plate Swivel Arm
B4 (x1) B5 (x1) C (x2)
M8x12 Bolt Wire Clip Wire Clip
J2 (x2) K (x2) L (x4)
2. Remove the screw and washer at the top of the M10 Hand Knob
and washer that were just removed. Select the preferred height according to your desk thickness. Connect C-Clamp
Bolt J2 , and tighten with Allen Key 5mm I . Rotate the hand knob N clockwise to fasten for stability. I
J1
B4
1
Option A : 39'' Pole Installation
Loosen the screws on the Lower Pole
3mm o . Connect Lower Pole
I
tightening the screws with Allen key 3mm o to fix the three poles.
Pre-Assembly
VESA Plate
D (x2)
A2
I
A1
A1
and connect the M10 handle , C-clamp
B4 B4
B4
B3
B1
B1
Hand Knob
A1 and Middle Pole with Allen key
A2
a1 a2
A1 , Middle Pole and Upper Pole by
A2 A3
a1 a2 a3
I
A3
A3
A2
A2
I
A1
and support plate with the screw
B1 B3
B1
to C-Clamp Brace using M8x12
B1 B2
B1 B2
B2
J2
I