Kenwood TM-702A Instruction Manual page 6

_
3-2. CONNECTION
3-2-1 Mobile Installations
Cautions :
1. Before installing the power cable, be sure to
remove the negative lead from the battery for
- Safety.
2. After installation and wiring, be sure to double
check for correct installation before reconnecting
the negative lead to the battery terminal.
3. If the fuse opens, be sure to check that each
conductor has not been damaged by short
circuiting, etc. Then replace with a new fuse of
the same rating. 7
4. After completing the wiring, wrap the fuse holder
with heat resistant tape to protect against heat
and moisture. :
5. Do not remove the fuse even if the power cable is | .
too long. :
A. Battery Connections
Connect the power cable directly to the battery.
terminals.Use of the cigarette lighter socket will lead to
poor connection, and will result in poor performance.
Pay close attention to the polarity of the cables when
connecting them to the battery. Remember Red is
positive and Black is negative! |
oy
Make sure the positive (+) and negative (-) lead polarity is correct
when connecting to the battery.
Engine compartment "A Passenger compartment
HSIND
Red Fuse
To the
transceiver
Select a location where
the power cable is pro-
tected from heat, mois-
ture or abrasion when | ©
securing the cable. 7
2 Chassis or
fire wall
Make sure the cable does
not directly contact the
edge ot ve the hole by using
@ gro
m@ If the wiring hole in the fire wall or chassis is too small, disas-
semble the fuse holder to thread the wire through the hole.
From passenger
compartment
Thread tike this
B. Ignition Noise
This transceiver has been designed to suppress ignition
noise; however, if excessive noise is present, it may be
necessary to use suppressor spark plugs (with resistors).