Hold/Resume Programming; Band Scan - Kenwood TM-702A Instruction Manual

144mhz, 430/440mhz fm dual bander
Hide thumbs Also See for TM-702A:
Table of Contents

Advertisement

4-5-2
Hold / Resume programming
Two types of scan hold / resume
have been provided in
this transceiver.
1.
@ The radio
is delivered
from the factory in-the
Time ©
operated
scan
mode.
To
switch
between
the
two -
Time Operate scan
You may select for the radio to stop on a busy chan-
nel, remain there
approximately 5 seconds
,and then
continues to scan even if the signal is still present.
. Carrier Operated scan
In this mode
the radio will stop scanning on a_ busy
channel
and remain
there until the signal drops out.
The radio. allows a 2 second delay before it resumes
scanning so that you do not loose the station when
operators
change.
Note
When CTCSS is on, the scanning stops only on the sta-
tions which
have
the matching
CTCSS
signal. When
DTSS is on, the scanning stops and audio signals are
received only when the DTSS code matches.
modes use the following procedure.
. Press the F key for longer than 1 second.The F indica-
tor will flash.
. While the indicator is flashing - press the VFO/MP> V
key. This will toggle the Scan / Resume
mode to the
Carrier operated mode.
To turn to Time operated mode repeat steps 1 and 2.
4-5-3
Band Scan
|
The entire frequency band of the main VFO is scanned.
1. Press the VFO
/MPV key to select the VFO mode. |
just the SQL control to the threshold point.
2. Press the BAND / DUP key to select either the VHF
UHF band.
3. Press and hold the VFO/Mb
V key for longer thal
second. The MHz
indicator will begin flashing to ;
nal the radio is scanning.
Press and hold for longer than 1 second.
Flashing
4. Scan
will begin
in an upward
direction. You" can
verse
the direction
of scan
by rotating
the Tun
control
counterclockwise,
or
by pressing
the
mic
phone DWN
switch. Clockwise
rotation of the
tun
control or pressing the UP switch will cause the ra
to begin
upwards
again.The
tuning
step
size
«
pends upon the current STEP selection
5. Scan will stop on a busy channel i.e a station that
strong enough to open squelch and turn on the BU
indicator.
6. You can cancel scan with any front panel key or 1
microphone PTT switch

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tm-702e

Table of Contents