FujiFilm PROFESSIONAL GW690-III Service Manual page 45

Hide thumbs Also See for PROFESSIONAL GW690-III:

Table of Contents

REASSEMBLY AND ADJUSTMENT

FUJI GW690-III (PROFESSIONAL)/FUJI GSW690-III (PROFESSIONAL)

3-6

Adjustment of parallax

After adjusting the range finder, check the left, right, top and bottom positions of the

picture projected on the focused plane, and then, look into the viewfinder to insure

that the image seen in the viewfinder frame agrees with the checked positions. When

adjustment is required, loosen two screws (5-67) and change position of the viewfinder

frame adequately. Or, it may be adjusted by slightly bending the interlock lever

(5-63).

Adjsut deviation between the viewfinder frame and actual picture size within range *1

below.

After adjusting the viewfinder frame, make sure that the viewfinder frame operates

smoothly and that the viewfinder frame is not tilted.

Then, finally, check the range finder once again for the infinite position, and make sure

that the left, right, top and bottom position are not deviated. If deviated, adjust it

with the eccentric pin (5-18) [For left or right] and adjust screw (5-27) [For top and

bottom], and then, install the cover (5-3) with two screws (5-2).

Table of Contents

Professional gsw690-iii