Table of Contents
Advertisement
DISASSEMBLY
FUJI GW690-111 (PROFESSIONAL)/FUJI GSW690-III (PROFESSIONAL)
IV.
DISASSEMBLY
1.
Removing the top cover assembly (3-1)
1-1
Apply a piece of rubber sheet to the shutter release assembly (1-13) and turn it to remove,
and pull out the film advance lever (1-18), stopper (1-19), shutter release shaft (1-20).
1-2
Remove four screw (1-1), and remove the top cover assembly.
1- 3
Unsolder and disconnect the lead wires (3-36 and 3-38) from the individual contacts by
using a soldering iron. (Refer to Wiring diagram for flash circuit)
NOTE:
When removing the top cover, recommend the shutter be charged.
2.
Removing the range/viewfinder assembly (5-1) and film take-up mechanism assembly (4-1)
2- 1
Set the helicoid assembly (7-62) to the close-up distance, remove three screws (1-3), discon¬
nect the lead wire, and remove the range/viewfinder assembly (5-1).
2- 2 Detach the spring (1-22) from the screw (2-54), remove four screws (1-4), set screw (1-21)
and washer (1-34), and remove the film take-up mechanism assembly (4-1).
3.
Removing the lens barrel assembly (7-23)
3- 1
Remove three screws (1-8), and remove the bottom cover (1-35).
3-2
Peel off the rubber grip (1-10) carefully so as not to damage it, remove two screws (1-31),
and remove the front left grip assembly (1-23) and shutter release (1-9).
3-3 Peel off the leather (1-11) carefully so as not to damage it, remove two screws (1-43), and
remove the front right grip assembly (1-36) and cylinder (1-42).
3-4
Remove four screws (1-7) and remove the lens barrel assembly from the camera body.
-
12
-
Advertisement
Table of Contents
